Close Up of LEH

Dual Telescoping Monitor Support Arm Bracket

Originally designed for the Ultimate sled, this has become extremely popular with all systems.

Two 1/2" stainless steel support rods supply rigid support, with a standard length of 6.5" rod length that allows you to position your monitor over a full 5.75" range. You can order the support rod in any length, 1/2" increments only.

Center post clam shell clamp design allows simple, quick arm adjustments. When flipping your monitor into low mode, operators need only to unscrew the Kipp handle three turns on the center post, then flip your monitor over and reattach.

The telescoping monitor support arm was designed to place the monitor in the best possible viewing position, quickly, allowing for maximum flexibility. It also allows you to spread your inertial mass of the system out for those windy days. Moving your monitor and batteries completely out will greatly increase your panning inertia, allowing your system to glide along smoothly. It wasn't designed for fine balance adjustments. However, coarse balance adjustments are possible.

Total telescoping range is 5.75" standard length, available in any length.

This arm is available for 1.375", 1.50", 1.58", & 2.0" post diameters.

Home Home | XCS Products